|
|
|
Tsurumi Pumps
LATIN AMERICAN DIVISION
|English|Español|
|
LH Series
Dewatering Pump
|
FEATURES
|
APPLICATIONS
|
|
1. Semi-open, High Chrome Iron impeller with replaceable/adjustable High Chrome Iron Wear rings, increases wear resistance, when pumpage contains abrasive particles.
|
1. Commercial, industrial dewatering and construction site drainage.
|
|
2. Double inside mechanical seals with silicon carbide faces, (both top and bottom) running in an oil filled chamber and further protected by a lip seal running against a replaceable, 420
stainless steel shaft sleeve, provides for the most durable seal design available.
|
2. Effluent transfer
|
|
3. Highly efficient, continuous duty air filled, copper wound motor with class B or F insulation, minimizes the cost of operation.
|
3. Decorative waterfalls and fountains
|
|
4. Built in thermal andmp;mp; amperage sensing, protector prevents motor failure due to overloading or accidental run - dry conditions.
|
4. Raw water supply from rivers or lakes
|
|
5. Double shielded, permanently lubricated, high temperature C3 ball bearings fated for a B-10 life of 60,000 hours, extend operational life.
|
|
|
6. Top discharge, flow-thru design enables operation at low water levels for extended periods.
|
|
MAJOR STANDARD SPECIFICATIONS
|
SPECIFICATIONS
|
STANDARD
|
OPTIONS
|
|
Discharge Size
|
4", 8" Npt (100, 200mm)
|
Available in all Stainless Steel
|
|
Horsepower Range
|
20 - 150Hp. (1.5 - 11Kw)
|
|
Performance Range
|
|
Capacity
|
100 - 1700Gpm (.37 - 6.4 cubic metre/ min)
|
|
Head
|
30 - 600Ft. - 100 Ft. (1.5 - 30.4m)
|
|
Maximum water temperature
|
104F. (40C)
|
|
Materials of Construction
|
|
Casing
|
Cast Iron
|
|
Impeller
|
High Chrome Cast Iron
|
|
Shaft
|
420 Stainless Steel
|
|
Motor Frame
|
Cast Iron, ASTM A48 Class 35
|
|
Fasteners
|
304 Stainless Steel
|
|
Mechanical Seal
|
|
Upper Seal
|
Silicon Carbide / Silicon Carbide (75 - 150 Hp.)
Silicon Carbide / Silicon Carbide (20-60 Hp.)
|
|
Lower Seal
|
Silicon Carbide / Silicon Carbide
|
|
Elastomers
|
NBR (Nitril Buna Rubber)
|
|
Impeller Type
|
Semi-open, solids handling
|
|
Solids Handling Capability
|
Strainer Opening Size
|
|
Motor Nomenclature
|
|
Type, Speed, Hz
|
Air Filled, 3600 Rpm, 60 Hz.
|
|
Voltage, Phase
|
208/230/460/575 V, 3 Phase
|
|
Insulation
|
Class B (20 - 30 Hp.), Class F (40 - 150 Hp.)
|
|
Bearings
|
Pre-lubricated, Double Shielded
|
|
Accessories
|
Submersible Power Cable 49' up 100 Hp, 65' for 120 and 150 Hp.
|
Length as Required
|
|
Operational Mode
|
Manual
|
TS-303 Float Switch
|
60Hz. PERFORMANCE CURVES FOR LH SERIES
50Hz. PERFORMANCE CURVE FOR LH SERIES
|
